After 1 year with problems with locking my car i found something.
2008 ford fusion door lock problems.
The rear passenger door central locking is no longer working either to lock or unlock.
Also the drivers door doesn t lock with the key fob.
It works fine when operated manually and you can hear something trying to work inside the door when you operate the remote but it doesnt actually man.
The contact owns a 2008 ford fusion the contact stated that the door locks were not functioning properly.
I have searched the net everywhere but the only thing i found was this.
Issues in ford cars door locks and central lock system.
At times when trying to get in the vehicle or once in the vehicle the doors would not unlock.
Ford fusion owners have reported 4 problems related to power door locks not working under the electrical system category.
For the driver to get out of the car you need to roll down the drivers window and open the door from the outside.
Can you give an idea of how expensive it might be to fix this problem ford fusion se 2011.
The 2008 ford fusion has 13 problems reported for door latch broke.
Average repair cost is 160 at 80 100 miles.
If you are driving a 2008 ford fusion or if you are planning to purchase one then it is important that you review reported latches locks linkages problems and defects total reports.
Also please check out the statistics and reliability analysis of ford fusion based on all problems reported for the fusion.
Many ford vehicles also provide an open trunk feature.
The contact owns a 2008 ford fusion.
Central locking problems finally a solution.
Hi folks i have a problem with my wifes 08 plate fusion.
Info and repair ideas.
Most ford vehicles now come standard with a keyless entry remote control.
While driving with the automatic door lock engaged the force was so hard that it broke the driver side door handle.
This allows you to lock and unlock your vehicle doors without actually inserting the key into the door handle.
Ford technical service bulletin tsb 05 10 21 says to clean any corrosion from the door latch connectors then pack them full of dielectric grease.
The power door lock on the drivers side stopped working today all other locks are working.